MardonSales's Store

Enrust - Gallon

Back to catalog

$70.75

In stock

Product Details

ENRUST neutralizes the rust and forms a tough black polymer primer.

With proper top coat selection, ENRUST will outlast conventional systems by 4 times.

ENRUST is a unique rust treatment, follow instructions carefully to obtain best results.

Instructions for use.

SURFACE PREPARATION:
1. Remove blistered, loose paint, loose rust scale and heavy rust buildup.

2. IMPORTANT: Remove all oil, grease, salt, or water soluble chemicals with high strength cleaner. Rinse thoroughly with fresh water.

APPLYING ENRUST:
3. Mix ENRUST thoroughly before using.

4. Pour the estimated amount needed for the job into a clean container. (note: ENRUST cannot be returned to the original container due to rust contamination).

5. Use of rubber gloves is recommended because ENRUST is difficult to remove from the skin.

6. For maximum penetration, work ENRUST into rusted surfaces with a synthetic bristle brush. On large areas use a roller or spray (airless spray is preferred).

7. For best results apply two thin coats of 1 ml.

8. Apply a 2nd coating within 20-30 minutes in a cross direction to previous coat. Allow to dry for 24 hrs., ENRUST dries to a black matte finish.

CLEANUP:
9. Clean all equipment immediately after use with warm, fresh water and dish soap. Once ENRUST has dried you are unable to remove it.

Coverage: 260 SQ. FT. per gallon 2 ml thick

Protect from Freezing

ENRUST dries to a durable matte black finish when applied to rusted surfaces and remains clear when applied to non-rusted metal or other coatings.

For decorative effect or maximum protection in high corrosive environments, a suitable top coat for the environment is recommended.

The More Rust the Better

Since rust neutralization and priming occur with one application, one step is eliminated from the treatment process. In addition, surfaces do not need to be completely rust free. In fact, the presence of some rust on the surface is actually beneficial when using ENRUST.

Environmental Conditions

The temperature of the air and the surface being treated should be between 50°F and 90°F. Do not apply in high wind conditions or direct sunlight.
Apply to clean dry or damp (not wet), clean surfaces.

DON"T JUST TREAT RUST - END IT WITH ENRUST!!!

How ENRUST Works...
1. ENRUST Treatment Applied	2. RUST Neutralizing Process	3. RUST Completely Neutralized

Converts rust to a stable black iron oxide magnetite and primes metal for painting in just one easy application!

Optimum uses of ENRUST

ENRUST is not recommended for use in applications where total immersion in water or any other fluid is required, i.e., the bottom of ships, ballast tanks, storage tanks; however, with a cross linked top coat such as urethane, or epoxy, ENRUST might work. The customer must test to their appliction and satisfaction. We do not recommend ENRUST for these applications without first testing ENRUST's performance.

Phosphates or oils on the surface must be removed before applying ENRUST.

Maximum protection is attained when ENRUST is properly applied and top coated with material best suited to the particular environment.

Typical Applications

Agricultural Equipment	Pipelines
Automotive Chassis	Railings
Bridges	Refinery Equipment
Chemical Processing	Shipping and Coastal Maintainence
Conveyors	Storage Tanks
Outdoor Furniture	Transmission Towers

Save this product for later

Enrust - Gallon

Back to catalog